Davidmccabe

They said it was out of 55 firedome

I am putting a different axle drive pinion flange and axle seal in my Desoto rear end does anyone now the torque for axle pinion flange nut

It buys the gauge at 220 I took the pump out it looked good I have bypassed the heater core

So far I flushed the coolant system and I removed the thermostat I am going to try to bypass the heater core water pump looks ok

I have a 201 plymouth that runs hot. It will idle for days without getting hot but once I try driving it it warms up I am afraid the distribution tube is dirty anyone ever have any luck with chemicals I don't know for sure that is problem just running out f options

Can someone tell me what gear oil I should use in the rear end of the desoto firedome

Thanks for the help I will pack the the bearings and hand spin in grease through the screw hole

Should the bearing be packed with grease before I put it in or is removing the screw and adding grease enough

I am rebuilding a desoto firedome rear axle I have put new inner axle seal new races and bearings and outer seal but what lubricates the bearing itself they didn't look like they were packed with axle grease before but that would be the only way for that bearing to be lubricated do I just pack the bearing and move on

It has 4.10 gears and need whole 3rd member in a 3.54 or 3.73 11 bolt 10 spline 8.25 inch

When looking for a Hollander book do I look for the year or the model

I have a1941 plymouthtruck I am looking to speed it up it has 10 gears I would like to buy 355 or 373 it has 11 bolt 10 spline