LehrBigBoy

What would be an approximate cost?

The manifold on the custom is actually a dual port that was also made for industrial engines. I wish I could find one of those. It would work also. And I had looked at the homemade ones by moose. As a last resort I will have one built. But I would really like to find an original, since the tractor is so rare.

I have none at all. It was stolen from dads shed. Most likely went to scrap.

Here is another tractor like mine. You can see why I can't use a car manifold.

I am looking for an intake/exhaust manifold setup like the one in the picture. It is for a short block 218/230 Chrysler industrial. It has a downdraft carb and exhaust that exits out the front top. I'm trying to restore a tractor, and I have to have this configuration, as the steering shaft is in the way of the lower rear exit on the car manifolds. I could also use the dual side port exhaust as well. Any help would be awesome. The original I had with the tractor was stolen from my dads shed. I did see one on here in January, that was what I was looking for. I'm going to try to tag the member.

That upper manifold is exactly what I'm looking for. The red one. Do you still have it? It fits a small block industrial with down draft carb and upper exhaust exit. Could you call or text me at 715-574-3470 if you still have it. Thanks Stephen.