FB IMG 1446611898807

I have started working on this again here in 2016..Here I have Rough fit the driver side floor pans together and tacked them down temporarily while i cut out the other side and fit it all together also have to build a firewall/tunnel to tie it all together.I will revisit this side later to drill holes and spot weld the pans to the braces as well as the inner rocker panel..Then i will fit the outer rocker over top of the pans and lap weld it to them. as for now you can see i have the front pans tacked on top of the outer rocker that is so i can move them easier while figure out a custom tunnel/firewall..flexibilty is key as i am building a custom not a stock restoration.