1950 plymouth deluxe gas pedal hinge?

[moparblood]

the gas pedal broke on my car. pedal fell off to the side.

its the cast hinge on floor. boke right below where its bolted on the pedal

does anyone remake these?

or do I have to custom make one?

[TodFitch]

I am not sure about the 1950 cars but the earlier ones have ball studs on the floorboard and the gas pedal just presses on. Replacement gas pedals are available from the usual old Mopar parts suppliers.

[Los_Control]

I'm not aware of any that used a hinge (cars in this era)  As Todd states, is the ball studs that is normal.

 

Mine was in pretty poor condition and should have just replaced it. I had a small 3" hinge and welded it to the pedal then attached the big foot to it.

 

 

 

You can cobble something together that works ..... or just buy a new pedal.

[JerseyHarold]

There are 4 small bolts that hold the gas pedal pivot bar bracket to the floor.  If the top of the pivot bar rusted out or pulled away from the bracket, you can cut small strips of metal to go over the top of the pivot bar, bend them to be snug, and secure them through the existing bracket holes.

[D35 Torpedo]

My 50 dodge has the cast hinge. You might be better off making one. I've seen one other broken off the same. 

[moparblood]

hey guys, its a cast hinge,  just looked up in the manual its a 

gas lever assembly 14-01-16

not easy to find.

I'd like to replace if possible

[50 coupe]

If you trying to do original, good luck on finding parts. I pretty much end up just making stuff. Of course my car is more of a Rat than anything else. LOL

[moparblood]

hey guys,  I've found it at desert auto,  not that cheap but I needed it.

thanks for info