Conn47D24 Posted June 16, 2021 Report Share Posted June 16, 2021 Is there a torque value to tighten these castlenuts before inserting the Cotter pin? Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted June 16, 2021 Report Share Posted June 16, 2021 none listed in the book....just the clamping nuts on the adjuster have a call-to torque. Snug them up....I would say bout 30 ft lb min and let the big dog eat...these are interference fit and all you assuring is the nut does not allow it to back off any. So snug them up good...insert pin...if pin is unable to go through..tighten it a bit more rather than loosen to to align the hole to the castle. 1 1 Quote Link to comment Share on other sites More sharing options...
Conn47D24 Posted June 16, 2021 Author Report Share Posted June 16, 2021 Thank you PA. Yes, book had no torque value. Appreciate the help. Quote Link to comment Share on other sites More sharing options...
bamfordsgarage Posted June 16, 2021 Report Share Posted June 16, 2021 8 hours ago, Plymouthy Adams said: …and let the big dog eat Now that’s a new expression to my ears. Mind you, I’ve always been a cat person… 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.