Jump to content
Sign in to follow this  
Rob

230 oil priming the engine

Recommended Posts

So I primed the pump on my new rebuilt motor. I want to prime the block. The motor has been sitting for about 3 years. It was built by a good shop, I did inspect and they did a good job of covering the cam with grease. I don’t want to turn the motor to get oil pressure if the grease is dried up some even with the spark plugs out. Question is, can I prime the motor from the filter inlet line to get oil to the crank and cam ? I don’t have an old oil pump to take the gear off of to go that route. Thanks

Share this post


Link to post
Share on other sites

Sounds good That’s why I’m asking, never have tried this so just checking. Thanks

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use