Rjpond Posted July 11, 2020 Report Share Posted July 11, 2020 My mission was to remove the vent window and take the whole assembly to the glass shop so they could replace the broken glass and install the new seals. So far I have removed the window regulator and carefully lowered the glass to the bottom of the door. I removed a small screw that went through the bottom of the vent window seal. Next I removed the nut that adjusted the spring tension that regulated the force needed to swing open. Upon closer inspection it looks like there are channels manufactured into the door frame at the top and below the vent window that prohibit the assembly from sliding out. The whole assembly will slide back and forth about a 1/4 of an inch but then it hits these door frame stops. what am I missing? Do I need to remove all the cracked glass? thank you Scott Quote Link to comment Share on other sites More sharing options...
Rjpond Posted July 11, 2020 Author Report Share Posted July 11, 2020 Took a coffee break and came back, looked over the situation and found the problem. I did not see the screw, that goes through the seal at the top of the vent window mission accomplished !!! Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted July 11, 2020 Report Share Posted July 11, 2020 score one more up to a cup of coffee...often you just need to walk away a bit and put fresh eyes back on the job a bit later.... 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.