Dennis Posted December 15, 2019 Report Share Posted December 15, 2019 We completed the front suspension rebuild/installation. Thanks to everyone for their suggestions. We are ready to install the tie rod ends. The grease seals for outside ends are different from anything I've seen before. The seal consists of a flat rubber washer, two steel washers and a spring. We are assuming the rubber washer is installed first followed by a steel washer, then the spring, followed with the second washer. Is that correct or should we replace these parts with a more common rubber boot? Thanks, Dennis Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.