SteveR Posted June 8, 2019 Report Share Posted June 8, 2019 I am getting grease from the front wheel bearing onto the brake shoes. The seal is in place but I am wondering what the correct size should be? Also what could I use to clean the shoes? I have heard that gas makes the grease/oil seep into the pads? Quote Link to comment Share on other sites More sharing options...
sser2 Posted June 8, 2019 Report Share Posted June 8, 2019 Seal shaft diameter 1.734", outside diameter 2.726", width 0.500". National /Timken part #5836, Victor #49237, Mopar 668479. Check for wear groove on the shaft surface, this could be a cause of seal leakage. There is also felt dust washer that seals backing plate, check if it is in good condition. If linings are impregnated with grease, replace them, do not attempt cleaning. 1 Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted June 8, 2019 Report Share Posted June 8, 2019 you can also remove your seal and then test fit to the axle for proper fit......be quick and easy check... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.