rferg Posted February 19, 2014 Report Posted February 19, 2014 3 spped manual trans when unable to get it into 1st and rev - check the screw on the side, under the top shift lever. It's a slotted screw head. after removal check the length of the shoulder past the end of the threads - should be about 1/4" if it's less - it's sheared off. If the pin shoulder is sheared, it allows the vertical shaft to move up, instead of the internal lever, so it can't engage the 1st/rev rake shaft. Use a magnet to find the sheared end (in the lube). Can't help in finding a new screw - I had one in another old tranny. 3 Quote
Papeenun41 Posted October 30, 2023 Report Posted October 30, 2023 Can you please send a picture of the screw you're talking about? Thanks in advance. Quote
larry montani Posted December 15, 2023 Report Posted December 15, 2023 hey rfurg, i'm having trouble with my three on the tree not down shifting from third to second. 49 ply. i looked at the tranny breakdown on page 204 in the service manual and can't find the pin your talking about. i did find the screw under the operating lever but can't get at it with tranny still in the car. i plan on dropping the tranny soon. but you didn't give any length or width of said pin. do you have anymore info? i talked to northwest transmission and they are stumped, they don't recall this pin .anymore info would really help. thank you in advance, larry Quote
FarmerJon Posted February 19 Report Posted February 19 On 12/15/2023 at 10:19 AM, larry montani said: hey rfurg, i'm having trouble with my three on the tree not down shifting from third to second. 49 ply. i looked at the tranny breakdown on page 204 in the service manual and can't find the pin your talking about. i did find the screw under the operating lever but can't get at it with tranny still in the car. i plan on dropping the tranny soon. but you didn't give any length or width of said pin. do you have anymore info? i talked to northwest transmission and they are stumped, they don't recall this pin .anymore info would really help. thank you in advance, larry It is just a 1/4-20 screw, .396 long (from under the head) with the threads turned off .160 of it, down to .150, and a lock washer. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.