Wheeling Dealing

[Plymouthy Adams]

little trading..some elbow grease and couple gallon of gas to fetch this baby home...bad news...3 phase..next step is to order the converter and I will be in business...now where the sam am I going to set it...lol its very heavy by the way...took three of us to load it onto the trailer..

 

 

     

[Merle Coggins]

It doesn't look too well used. Good find. Maybe you'll have to build another addition onto your garage for a "tire shop".

[Plymouthy Adams]

Thanks Merle. I just finished printing the operators manual off the Coats website, good site, all the stuff there including calibration instructions as these unit self calibrate.  I am thinking I will remove a stainless steel  work table that is relatively close to the door where my tire changer is located..I am not in the mood to build onto the shop at this time.    

[Mikemomd]

Oh....I thought you went to Wheeling to do some dealing, Tim??? If you did, you better stop by and say hey!!!!!

[Plymouthy Adams]

I have been to Wheeling/Weirton area one time in my life...that was one long drive from my family home in SW West Virginia...way back then there were no corridors built thus driving time though small towns and back mountain roads was at best time consuming..If I drive to Charleston..maybe you could drive a few miles and we meet up somewhere..I will be quite busy when there doing house/property repairs for my aged aunt....goof off time is at a premium...

[Don Coatney]

I should have snagged that 3 phase motor my heighbor offered me. You could have used it for a converter.

[Plymouthy Adams]

Don..I tried to tell you that...never pass up a good deal especially when the price is so right as that one was.....

 

I am going to order the actual converter designed to go in, correct pigtails and clips and will bolt direct to where the stock converter position is as designed by the factory...