-
Posts
169 -
Joined
-
Last visited
Reputation
10 GoodAbout slicknapier
- Birthday 08/12/1977
Converted
-
Location
Tucson, AZ
Contact Methods
-
Occupation
firefighter
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
Hey Oil Soup, I grafted a Volare front clip to my original 48 Panel Truck frame. I ended up not using it and built a complete frame with a Dakota clip. If you are thinking of doing a clip let me know. I'm not sure if the frames are the same, but I have the complete rolling frame that I'm not using. I would sell it to you cheap if you are interested. I live on the eastside at Houghton and Broadway, but the frame is at my parents house near Benson. I don't get on here much so email me if you might be interested, andrew slicknapier@yahoo.com or call/text 979-1539
-
well turns out my threads are to stripped to work with. I'm going a different route on the threaded part. Thanks for all of the replies though..
-
Let me know if you need anything else..PM me just in case I don't see this post. I'm on the truck side more than the car side.
-
-
-
Here are the measurements I got today off mine. Hopefully they help. First picture is the top hinge in the rear. It measured right around 44 1/4". It appears the doors taper a little, the bottom hinges measured just about 45". The b post at the door latch inside measurement was 60".
-
I will try to measure mine tomorrow.
-
I'm here! What exactly are you looking for? I've changed alot on mine, but might be able to help out..
-
seems the hardware store fine threads are all 5/8-18..
-
Cool thanks. Is that nut available?
-
Is there anywhere besides ebay to buy a steering wheel nut for my 48 Dodge Panel truck? $20 seems a little steep for a nut. If it's a last resort I can stomach it, but if there is someone out there that has one or knows of a place to get it that would be great. Also, just to confirm that it's 5/8"-20 thanks, andrew
-
That's the one I would pick..
-
steering wheel identification and spline help
slicknapier replied to slicknapier's topic in P15-D24 Forum
Well Bob, you were right. The wheel does fit on my panel trucks original shaft. I swear I had already tried it, but I guess not! -
steering wheel identification and spline help
slicknapier replied to slicknapier's topic in P15-D24 Forum
Yah it doesn't fit on the 48 Dodge Panel shaft... -
steering wheel identification and spline help
slicknapier replied to slicknapier's topic in P15-D24 Forum
awesome. thank you..Now to find a shaft for one to make a column!