SSD

Thats genius

I have the manual 3 spd in my 47 truck have the stuff for the t5 swap but a poweflite has been stuck in my head, would a poweflite out of a car be bolt up as long as i had the bellhousing and converter?

I have the manual 3 spd in my 47 truck have the stuff for the t5 swap but a poweflite has been stuck in my head, would a poweflite out of a car be bolt up as long as i had the bellhousing and converter?

Ok so I have a couple part numbers not sure what one is right for my 47 truck first I found the 256ls under the auto section of the catalog then I found the 1361a under the indrustrual section anyone know what one is corect?

Ok got to the bottom of everything I think, didn't recive all the bushings and that was throwing me off think I'm all good now

I got the adapter kit from Langdon was ordering a clutch disk when I relised I may have a issue

Or I may be totally misunderstanding how this kit goes together, I've read the instructions got the bushing that didn't come with the kit, I'm getting a bit flustered I'm a machanic/welder by trade and I can't figure how this goes together

The physical size of the shaft is different correct? The 14 spline is 1" and the 10 spline is 1 1/8 I thought

Ok think I may have snatched up the wrong t5 for my kit from tom Langdon, it's a 14 spline trans I need the 10 spline don't I tag number is 1352-193

Ahh thanks I was wondering about the skirt length, I may be missing something but a lighter piston would cut down on rotating mass, or do these engines need the long skirt. Not that I need a rebuild just wondering out loud because my shop has the ability to make rods etc

Ok was bored and was browsing summit and found these now the motor mounts look correct but what about the carb kit and the pistons I'm most worried about the carb kit thanks y'all

I know it's a old thread but what size tubing did you use

Ok cool thanks

It's for sure a 12v battery I'll have to get a part number off the alt to know for sure

Ok I just went out to look at my truck first time in a while life got in the way but I was getting a part for the the battery and it looked like it was pos ground but it has been converted to a 12v battery and alt so I guess it it possible to run a alt with pos ground