Jump to content

johnp

Members
  • Posts

    13
  • Joined

  • Last visited

Reputation

0 Neutral

Profile Information

  • My Project Cars
    41 dodge

Converted

  • Location
    Chicago
  • Interests
    Mostly antique autos

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. going to install new master cylinder. Should i just tap this pedal .rod out? John
  2. johnp

    Bunpers

    Thanks to all. Looks like steel rubber has the closest to the original. John
  3. johnp

    Bunpers

    Thanks anyway.tried the hood bumpers hole is too big. Here is a pic of other side. Did not try prying these out yet they are rock solid from age. John
  4. johnp

    Bunpers

    41 dodge 4door does anyone know where I could get the rubber bumpers that go on the top of the center pillar bermbaum showed me the ones that go on the front post with a screw through it they won’t work in the center. John
  5. you know my dad had mentioned he had a 1950 cryhsler Windsor . Back then he said in the summer he would run straight water little bit of rust inhibitor and no thermostat and then but it back for winter.
  6. had the pin fall out on my pump . had to have the car towed home . next pump put j b weld on both sides of pin so far good. John
  7. thanks to all Itry the hardware first John
  8. does anyone have a extra hood spring that they do not need? John
  9. thanks to all. I will check the choke and linkage first. john
  10. have an automatic choke sisson i think its called Iwill check that again spray the linkage. not with wd40 though John
  11. had carburator rebuilt last year recheck float level good accelerator pump works tightened intake manifold bolts carb screws - heat riser works changed plugs -checked condenser -replaced small wires in distributor -breaker plate moves free had the vacuum advance rebuilt no leaks- the timing is couple . of degrees advanced. Like I said after runn nig for a couple of minutes runs great. Thanks , John
  12. have a 1941 dodge starts right up hot or cold idles fine .But until it warms up there is a hesitation . If i shut the car off for 5 and start it still ok. lets say I go into the store for 15 min start it same thing there is a hesitation until it runs for a little bit. Once its warm doesnt do it anymore .Looked at the posts on here checked the things they said anybody with similar problems? John
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use