Danielle
-
Posts
39 -
Joined
-
Last visited
Content Type
Links Directory
Profiles
Articles
Forums
Downloads
Store
Gallery
Blogs
Events
Classifieds
Everything posted by Danielle
-
Mine runs along the top of the driver's side door but then I lose it.. does anyone know where it ends?
-
Hi hang, Can someone tell me where the fuel sending wire leads to.. doesn't say in the book and I'm afraid on pulling on the wrong wire forward of the back seat.. also what gsuge ?! Thank you!
-
I just got rubber sheets from home depot 1/16 inch
-
Thank you! Will do
-
I appreciate the picture Bob.. my dilemma are the hooks.. which way are they facing
-
Dj I strengthen then to clean them is why
-
Can someone show a picture of the proper placement of the fuel tank straps.. Manual doesn't provide.. tank you!
-
Good morning guys Can someone tell me what size the wires are at the fuel sending unit.. my manual is cut off at the back of the car only shows the turn signals .. thank you
-
I was gonna say ... I didn't come across that lol.. thanks sniper.. I'll take that hose with me when I go to the parts store...I was concerned with the material.. seems almost cloth like.. original maybe ? But if rubber is fine than rubber it is
-
Secondary queation. I've been looking for a replacement hose that's connected by the two claps with no luck. Any universal type hose that is fuel tank safe ?
-
Thanks I was able to fish the tank and the pipe on through as one. Mighty rusty little screws I will have to deal with tomorrow.. say, while pouring the gas out a bolt came out.. the sending unit looks to be on tact.. any idea what that could be? I tried to upload a picture but it didn't let me.. it was pretty large.. like a fitting of some sort
-
Trying to drop the tank.. I've removed the two bolts holding the straps.. removed the sending wire.. the fill pipe is what I'm having issues with. Please advise
-
Can someone send me a picture of there setup to include the linkage bolt.. not sure if it goes above or below also the snap ring is being a real PIA. If I put it in first it won't leave any play to cover the manifold side bearings
-
Thank you sniper.. btw I went ahead and ordered a new fuel pump.. did the gas can steps and no workie ?♀️
-
Can someone tell me what the purpose of the wire connected into the tank from the trunk is for? It looks really brittle If I were to replace it what Gauge is that
-
Anyone know how to test the pump.. while it's out? Also I got it leaning to one side.. the cupping side.. no fuel coming out.. however lean it to the other side and fuel drips out the nip
-
I guess I will have to look into adjusting that rig someone made.. not me I promise ?
-
Yeah I found a bolt on the manifold with what use the be a gasket.. but just one bolt
-
Sniper can you take a picture of yours
-
Rich, Is this it ? It leads straight inside the dash
-
Dartgame, I followed the steps yoy gave. It cranked stayed on for 4 seconds and dies. Removed the hose from the inlet and it was wet with gas. So it's sucking up fuel but I pushing it out.. or alternatively it's not getting sucked up from the carb.. I checked the steel line into the carb and it was bone dry
-
Good advice! Getting up to do that today.. I forgot the size of hose.. any idea?
-
Front facing angle
-
Should the fuel pump be full.. I'm not getting fuel to the carb. I removed the steel line into the carb turned it over.. dry.. I then went down to the far end hose on the pump dry... I blew are down it and can manage to hear air blow.. loud air compressor.. so if I have a bad pump, is there a kit? I really don't want to do electric as I don't know if I have to remove the bulb style and flaring lines I'm terrible at..
-
Thank you 61 split! Yall thank you so very much for all yalls quick answers. Best to ya
