Jump to content

Bobby198412

Members
  • Posts

    27
  • Joined

  • Last visited

Everything posted by Bobby198412

  1. Used an axle puller or slide hammer
  2. I ordered two 28521 part number. For 1948 plymouth. That's what's in the book for a outside rear cup. But when I get them the are like 4 inches in diameter and to big to fit into the house for the diff. Does anyone know the correct size or cup I need? They need to be like 3.2 inches not 3.8 inches. Even Rockauto sent me 3.8 inch cup.
  3. I haven't taken it out yet. I can't see a number. Just assumed someone who know the part number so I can order it and get the part here faster.
  4. The cup or race over the rear passenger bearing. I have taken mine out yet.
  5. Can someone please tell me the part number for the rear race for a 1948 plymouth 4 door. I haven't pulled mine out yet but want to order the correct one. Thanks
  6. Can someone send me a link or show me a good one to buy to remove a rear axle from my plymouth! Thank you
  7. Can someone show me the correct slide hammer to purchase? I need to do the exact same job. Thanks
  8. So do I need to remove the bolts on the rear differential? How does the axle shaft come out of the rear diff? I read the manual and I'm not getting it. I'm newbie to this.
  9. I'm replacing the axle and it see I need an inner and an outer seal. Also how many bearings do I need? 2? Thank you
  10. I haven't taken off the axle stub/axle spindle/axle. But is 32 1/4 inches the right length of a pass rear?
  11. Ok I will take a picture today.. Around 630pm when I get home from work.
  12. No not doesnt. I found a kit but it's for an eddlebrock. Not sure it will work.
  13. I was wondering where I could get this arm/linkage. The top is broken and I can't get the clip on it. It keep popping out of the hole.
  14. Can some one tell me what size fuel line I need to run from the fuel pump to the gas tank. Also what size compression nuts I need so that I can flare the ends and connect the new line with the pump and new tank. Thanks. 1948 plymouth deluxe
  15. I looked on her for manuals there isn't anything I need. Also whwre is the beset place to look for a 6v wiring harness for my car ?
  16. I have a manual but I don't get any numbers on the wiring print. I'm looking for something like that to help.
  17. Without buying a harness. What awg wiring do I use to redo everything. Headlights, horn, under dash, dom lights, parking lights, brake lights.
  18. And the distributor cap which is 1 2 3 4 5 or 6.
  19. Can someone tell me the order to wire this up ? And which spark plug is #1 and #6 on the engine.
  20. I've been looking. Nothing for headlights, choke or throttle. Just defrost..
  21. I haven't seen the back ones. I kind of like then better then the original. Thanks
  22. I'm looking for these ivory knobs. Or maybe repros. Need some help. Thanks
  23. So I picked up a what is said to be a Plymouth p15 from 1948. But I'm alittle confused cause the dash doesn't look like any that I've seen online. Im new to this and just wanted to see if its definalty a 1948 .
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use