Jump to content

Conn47D24

Recommended Posts

Today I installed the clutch linkage.  New clevis pins were in order as originals were badly grooved.

Found close to stock size.  Slightly larger required washers to keep rods from sliding side to side.

I need advice on the position of the rod and turnbuckle.

The rod seems too close to the bell housing. Is this correct?

Also, do I have the offsets on the turnbuckle installed correctly on the pins?

Wasn't  sure how these angled offsets were supposed to face.

Thanks for and help or photos!

20190216_161438.jpg

Link to comment
Share on other sites

14 minutes ago, Conn47D24 said:

Thanks. Clearer than my parts book but these don't show

The turnbuckle orientation with the angles on each end.  

Still concerned also about the rod so close to the housing. 

Any photos out there?

I have this photo showing the angles but can't help you with photos of clutch housing as mine has  the larger Fluid Drive housing. 

Yes looks a bit close. Has fork slipped from pivot #47? Or bearing #48? Both held by clips

1.pdf

Edited by chrysler1941
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use