belvedere Posted September 19, 2018 Report Share Posted September 19, 2018 This is the cap that goes near the front main cap...the front cover attaches to it (sorry, not sure of its correct name). The FelPro gasket set provides a couple of O-rings that are meant to be trimmed and installed in the grooves on the bottom of the cap. My question is, where do I trim the o-ring? Flush with the edges of the cap, or leave a little extra? Thanks! Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted September 19, 2018 Report Share Posted September 19, 2018 (edited) if I am reading this correct and you are to lay these in the grooves....you do not want it too long and chance it rolling out of place when assembling the unit....cut for a general non stretched fit as in laying under its own weight, apply some sealant at the cut corners... Edited September 19, 2018 by Plymouthy Adams Quote Link to comment Share on other sites More sharing options...
belvedere Posted September 19, 2018 Author Report Share Posted September 19, 2018 Thanks PA. Yes, they fit into the grooves. It is actually a tight fit, and they will not fall out once pressed in. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.