Jump to content

Ignition Switch


Recommended Posts

so 2 months i took the ignition switch out and took it to a local lock smith for a new key, it was fresh in my mind then so i didnt mark or tape which wire went to which. there is a long wire and 2 wires that are the same length. i can see the Batt, GA and IGN. Any help will be appreciated!

Link to comment
Share on other sites

One wire should be coming from the Ammeter. This one would go to the BAT terminal. The wire diagram shows 12 ga. Brown.

The IGN terminal gets the wire that goes to the ignition coil. 14 ga. Red, according to the diagram.

The third wire feeds the gauges, primarily the fuel level gauge, or any other powered accessory. This would go to the GA terminal. Diagram shows 12 ga. Blue.

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use