Search the Community
Showing results for tags 'Hopeedup'.
Found 1 result
Hey everyone, Recently I have gotten the time (and funds) to continue, and hopefully complete, my engine rebuild on my 230 Flathead. About 6 years ago I purchased a '55 Flathead from a buddy, while taking an engine rebuilding course at my nearby community college. This was after learning my lesson when buying a cracked engine from an unmentionable forum. After finding the one my buddy sold, I began the teardown. I photographed as much of the teardown as I could. I'm also pretty anal (can I say that here?) about labeling everything. I zip-locked each bolt set and labeled their size, count, and where they belonged. Now, here is my issue: After receiving my 230 crank from a local shop I am ready to plastigage it with the bearing caps, but I don't remember how my caps go. Attached is a photograph of my setup. I could have sworn I stamped them, but also notice there's oil caps, as well. I have looked through my Service Manual from 1955 and don't see any diagram or illustration as to the order in which these caps go. I've checked images online of similar engines and nothing close to what I'm looking for. Long story short, if anyone has any photographs of their rebuild on a 230 I would really appreciate a shot of the bottom end install. Also, Could I get away with replacing my Bearing cap bolts with some grade 8 bolts? I have called various suppliers (i.e. Burnaby and Vintage Power Wagons) and they don't carry any. Any info would be appreciated! =Adrian=