This is how I did it. disassembled the electronic dist. used a long bolt thru the body, chucked in in drill press, put rubber band around cap hold down clamps, set drill press on slowest speed, filed down body part that goes into block. You don't have to remove much metal, reassemble the dist using the shaft from the points dist, (same size shaft) . Don't use the 0 ring gasket on the electronic dist as it wont let the housing go in all the way. I used a 0 ring gasket at the top of the engine block, didn't leak. The dist hold down adjustment is from the points dist. Mount the control module and wire it up. Got my wireing instructions off the internet. I'll post pics soon. Mike