oldcarlover

I have new bottom door weather strip for my 1936 plymouth coupe that I purchsed from Andy B's. The rubber strip measures 1 5/8" wide. The shape resembles the lower case letter "h". Not exactly sure how it should mount to bottom of door. I would appreciate any suggestions.

My 1950 plymouth six flathead has got a small rear main bearing leak that is really bothering me. I picked up a rope seal kit but would like some advise on installation. Thanks

Need to replace all rubber parts for my restoration. There are several sources for these parts , but can anyone reccomend any particular one? I want the highest quality parts availabe.

Recently converted to 12 volts. Can I use my original 6 volt cables on a 12 volt system?

On my 1936 plymouth, 2 hoses come out of the firewall. Does it make a difference as to routing of the heater hoses to the 2 shut off valves. There is one valve on the water pump and the other at the rear-end of the head.

I just converted my 36 ply. to 12 volts. Where can I find a 12 volt heater motor that will fit into the unit like the original 6 volt. Also, can I use the original switch with the 12 volt motor?

just recently got a drag link rebuilding kit from Andy B. for my 36 ply. As usual no instructions. no help. Does anyone know where the 3 and 1/2" cotter pin belongs?

I have drive-train parts, brake master cylinder, gauges, wheels and tires, axle seals, wiper motors, dual exhaust manifold, 6volt bulbs and many other related parts. Selling all parts very cheap. Need room in garage! No reasonable offer refused!! Call 732-534-5027

Dear Sir, I tried making my own jig to remove the steering wheel. It won't budge! I have tried all over to find the tool that you have pictures of. I come up empty. I am stumped at this point. I would be glad to send you a check to borrow your tool if possible. Please get back to me. Sincerely, Frank J Rizzo 5 Pembroke Dr. Jackson, N.J. 08527 Home 732-534-5027

Need to remove steering wheel from 1936 ply. Got the nut off but do not know what type of puller to use on wheel. Also is there any smaller aftermarket wheel that will fit on the stock shaft?

Need to remove steering wheel from 1936 Ply. Took the nut off but do not know what type puller to use. Also is there any aftermarket smaller wheel that would work with the original shaft?

My 36 plymouth has 6 1/2 '' sealed beam headlamps. These are 6 volt lamps. I am switching over to a 12 volt system. Where can I find these 6 1/2'' round sealed beams in 12 volts?

I am hooking up a !998 Dakota ax15 tranny and rear into my 36 plymouth flattie. Can anyone give me any feedback on this combo.

I know there are many sources for rubber parts. I don't mind paying for a well made piece. Can anyone recommend a reliable outfit?

Looking for an overdrive tranny from 1936 - 1939 plymouth