NiftyFifty
-
Posts
2,263 -
Joined
-
Last visited
-
Days Won
5
2 Followers
Single Status Update
-
I have been working on ol rufus and laid out the omni rack every thing looks ok. When you posted a picture of your tie rod modification is that a solid stock drilled out to to fit both the rack and the old dodge tie rods? I could not locate any discussion on the tie rod ends. thanks for the help.
-
Good to hear, yes I had a machine shop drill out solid stock, think it was around 1 1/4”, 1/2 way for inner tie rod tap size and 1/2 way for outer. Only thing I would change is you should have a jam nut against both ends, I only did the inner side because the outer was very very tight to get on anyway.
i also used two of the same r/h thread outlets, vs original uses one r/h and one l/h
-
Thanks heading to the metal shop and have that done as well as putting 90 on the 1/4" plate. The slant six fit real well removed it to do this work and hook up the brakes. I finely see some light at the end of this build.
-
-
1
-
- Report
-