james Callahan

The one on the right side, should,t both rear wheel turn at the same time? I have not drove my 1950 dodge coronet in a year I have Bias Coker Tires on I thank they has Flat Spot on them I had to Jack up the Rear End to get the one Wheel to Turn. Thank You James Callahan

Where would be the right place to put my floor jack and two jack stands under my 1950 Dodge Coronet, to install a new fuel pump ? Thank You james callahan

Will the steering box on a 1950 Dodge Coronet, accomadate a small block 350 Engine, is there enough room? Has this been done before by anyone? Thank You James Callahan

T. shirt is good

Has anyone Install Manual Rack and Pinoin in our cars 1950 dodge coronet, and if so did it work very well ? Thank You James Callahan

gas is $ 1.48 in Wichita, Ks James Callahan

I found them there is a metal plate under the rear arm rest pry it off and the two screw are there. ThankEveryone

No the rear arm rest is on the door panel.

Help I don,t see the heads of any screws in the rear arm rest on my 1950 dodge coronet 4 door, how do you remove them ? Thank You James Callahan

I was on the old board and still used the same name don,t post as much any more. James Callahan

I got the message this morning in my pm mail box ? James Callahan

I have the new type in my 1950 dodge coronet, I was told that I need the old "bellows" type with the four by-pass ports. And I have the new water pump to the one with ball bearing, not the old type with the grease nipple, but on the new water pump, the back cover plate is off set a little from the hole in the water pump the too hole do not line up even, I was told that would not hurt any thing? any comment Thank You James Callahan

Has anyone use a adapter from Wilcap Company, behind our flathead 6 engine 230, to a chev 350 trans does our engine have the power to drive the automatic trans and if so how do you like the way it drive ? Thank You James Callahan